Jetter Nozzle Selection
Nozzle Selection Nozzle selection requires you to look at the pressure and flow rate of your pump and the size of the pipes you intend to clear. Below is a chart giving guide lines to Nozzle size selection against the pipes that they are intended to work in (Fig 1.0) this is for our streamline jets for clearing blockages using this guide will help you get the most from your machine and labour. Nozzles used on small hoses like 3/8” or 1/2” give good accessibility in tight ubends and small pipes generally found in domestic work. Jetter hoses rom 3/4”...
1/4″ Bsp Nozzles
Our 1/4 Jetter nozzles are ideal for those difficult to reach areas measuring only 18mm at the widest point. These nozzles will blast into blockages in smaller diameter pipes and drains using less water than larger jets. Available in three or four back configuration and with or without a front jet depending on your needs and operating on as low as 10 l/min no job is to small any more. Three back version is ideal for lower flow rate machines while still giving good traction and cutting if you need extra pulling power then choose one without a front jet...
EU VAT regulations
We notice that most of our clients from EU countries do not use their Vat number when ordering drain jetter nozzles from both our on-line store and over the telephone. If you are the holder of a valid EU VAT number, you do not need to pay Vat on nozzles from other EU countries. Here is a useful link explaining how this works. http://europa.eu/youreurope/business/vat-customs/cross-border/index_en.htm